HS51 Large Capacity Simple Digital Stirring Hotplate 115V 12A from Torrey Pines Scientific

Controls (Digital/Analog) Digital
Multiposition No
Min Speed (RPM) 100
Max Speed (RPM) 1500
Max Stirring Quantity/Capacity (L) 10
Min Temp Range (°C) 25
Max Temp Range (°C) 450
Heat Output (w) 1400
Plate Diameter (mm) 305
Plate Material Ceramic
Timer Yes
RS-232 Yes
USB No
Brushless DC motor No
CE approved Yes
CSA approved Yes

The EchoTherm HP51 and HS51 are designed to be the easiest to use and most accurate fully featured hot plates and stirring hot plates in the world. Temperature measurement of a solution is accurate to 1% over the entire temperature range using a 100 ohm platinum RTD sensor and measurement system.

Calibration of temperature is electronic and stored in memory. The calibration is set at the factory but can be done easily in the field using the probe calibration kit offered as an accessory.

The chassis on both models is cast aluminum designed to keep spills and heat out of the electronics. They are coated with chemically resistant epoxy based paint for durability.


FEATURES:

  • Extremely easy use by anyone in your lab
  • Two memory buttons for storing your favorite settings for heater and stirrer for instant, one-button recall and use
  • Platinum RTD temperature measurement for precision and accuracy
  • Solid ceramic heater top for quick heating on a flat, white, chemically resistant surface. Milled flat cast aluminum top also available
  • Temperature range from room temperature to 450C
  • Cast aluminum framed ceramic heater top edges stay cooler to prevent burns
  • PID temperature control for exact, tight sample control of plate or solution
  • Timer goes up to 99 hours, 59 minutes, 59 seconds with settable Auto-Off for exactly timed sample preparation
  • Electronic calibration stored in chip. No batteries to replace
  • 12” (30.48 cm) ceramic glass or aluminum tops
  • Strong motor and magnet for stirring most samples
  • Stir 10 liters of aqueous solution
  • Full featured digital display for checking all parameters instantly
  • Fused for safety
  • ETL, CSA and CE certified
  • RS232 interface for control or for data collection on a computer

The product descriptions and attribute groupings and assignments on this page are protected by copyright all rights reserved. If copied you will be persecuted against to the full extent of the law including infringement charges up to $10,000 USD per page of content.

Brushless DC motor: No
CE approved: Yes
CSA approved: Yes
Controls (Digital/Analog): Digital
Timer: Yes
[Lab Stirrer] Heat Output (w): 1400
[Lab Stirrer] Max Speed (RPM): 1500
[Lab Stirrer] Max Stirring Quantity/Capacity (L): 10
[Lab Stirrer] Max Temp Range (°C): 450
[Lab Stirrer] Min Speed (RPM): 100
[Lab Stirrer] Min Temp Range (°C): 25
[Lab Stirrer] Multiposition: No
[Lab Stirrer] Plate Diameter (mm): 305
[Lab Stirrer] Plate Material: Ceramic
[Lab Stirrer] RS-232: Yes
[Lab Stirrer] USB: No


Back To Top
We are fully compliant with the GDPR laws. We promise to safeguard your data and protect your privacy rights.