HS70 Fully Programmable Digital Stirring Hotplate 115V from Torrey Pines Scientific

Controls (Digital/Analog) Digital
Multiposition No
Min Speed (RPM) 100
Max Speed (RPM) 1500
Max Stirring Quantity/Capacity (L) 2
Min Temp Range (°C) 0
Max Temp Range (°C) 450
Heat Output (w) 600
Plate Diameter (mm) 203.2
Plate Material Ceramic
Timer Yes
RS-232 Yes
USB No
Brushless DC motor No
CE approved Yes
CSA approved Yes

EchoTherm™ Model HS70 Corrosion-Resistant Fully Programmable Digital Stirring Hot Plates are the most advanced and easy-to-use units available. They are designed with a purge port for infusing an inert gas, such as lab air, into the chassis of the unit. This positive pressure inside the chassis causes the gas to flow out of any openings and prevents corrosive gasses form entering the chassis, improving unit life greatly. In manual operation, simply select the parameter to be set and scroll to the value needed. The unit will do the rest. In the programmable mode, routines can be stored for instant recall and use. The stored routine will run automatically, without attention, and exactly the same time after time.

Programs can be simple or complex depending upon the need. Multiple temperatures, temperature ramp rates, stirring speeds and timed events can be stored. When run, the unit monitors the program to be sure it runs exactly as written. Complete walk-away automation.


FEATURES:

  • 10-program memory stored in CMOS. No batteries required
  • Each program can be 10 steps, where each step includes a temperature, stirring speed, time and heating rate
  • Repeat any program 1–98 times automatically. Infinite repeats settable
  • Programmable and non-programmable operation
  • Platinum RTD temperature measurement for ±1% accuracy
  • 8” solid ceramic heater top for quick heating on a flat, white, chemically resistant surface
  • Settable to 450˚C in 1˚ increments
  • Temperature ramping for exact heating and cooling rates
  • PID temperature control to 1°C on plate surface or solution with probe
  • Stir up to 2 liters of aqueous solutions from 100–1500 rpm
  • Timer goes up to 99 hours, 59 minutes, 59 seconds with user settable Auto-Off
  • 6” ptfe probe provided
  • Electronic calibration stored in CMOS
  • RS232 interface for control or recording data on a computer
  • NTP pipe-to-pipe, ¼” purge gas fitting on rear of chassis
  • 12-month warranty
  • UL, CSA and CE compliant

The product descriptions and attribute groupings and assignments on this page are protected by copyright all rights reserved. If copied you will be persecuted against to the full extent of the law including infringement charges up to $10,000 USD per page of content.

Brushless DC motor: No
CE approved: Yes
CSA approved: Yes
Controls (Digital/Analog): Digital
Timer: Yes
[Lab Stirrer] Heat Output (w): 600
[Lab Stirrer] Max Speed (RPM): 1500
[Lab Stirrer] Max Stirring Quantity/Capacity (L): 2
[Lab Stirrer] Max Temp Range (°C): 450
[Lab Stirrer] Min Speed (RPM): 100
[Lab Stirrer] Min Temp Range (°C): 0
[Lab Stirrer] Multiposition: No
[Lab Stirrer] Plate Diameter (mm): 203.2
[Lab Stirrer] Plate Material: Ceramic
[Lab Stirrer] RS-232: Yes
[Lab Stirrer] USB: No

Back To Top
We are fully compliant with the GDPR laws. We promise to safeguard your data and protect your privacy rights.